Import Plinths in IMPACT
Last modified by Thomas Gitsas on 2021/09/07 11:13
New Settings added in Tekla Base tools for Plinths
Set Profile Source as Plinth: When selecting this setting, the IMPACT Element Mark will be the same as the "Main Part profile" of the element in Tekla. In other words, the element will not have a serial number, but only the part number from Tekla. This can also be used for pre-made Tekla blocks with the same properties.
Set Cast Orientation as FAR FACE: When selecting this setting, the element in IMPACT will have the cast orientation set to Farface (this applies only for linked elements).
Note: You can always change the cast orientation in the IMPACT Project Manager under the linked element's properties. The new orientation will not be affected when resaving the elements in Tekla Base tools.