Is it possible to show the center of gravity in elements?

Last modified by Niklas Palmgren on 2019/04/24 09:10

Typing "DDPTYPE" enables the COG, center of gravity, to be shown in elements. This works on the floor plan and not in the shop drawings. The mass of the element is presented (e.g. for formslabs the end stops are not included.) 


Figure 1: Command: DDPTYPE in AutoCAD

In the gif below the COG is shown and then hidden. The second point style makes the COG disappear. 

show center of gravity.gif


Created by Niklas Palmgren on 2019/04/24 09:10
Copyright 2018 StruSoft AB
Impact Documentation