Unitechnik

Last modified by Kristofer Hellman on 2020/02/17 15:22

General

Unitechnik file exports are enabled in IMPACT. The file formats supported at this time are Unitechnik 5.2 and Unitechnik 6.0. Unitechnik files can be read by many CAM-systems (stackers, bending machines and lasers).

Workflow

Unitechnik files are created in IMPACT for AutoCAD.

Contents

The documentation herein focuses on the configuration needed to get the correct Unitechnik files for your specific application.

Configuration

Configuration of the file content and naming is done in the Unitechnik tab in Project Properties.

Configuration - General

Configuration - Model

The Unitechnik file format has a limitation in X, Y coordinates. When exporting to Unitechnik 5.2 format, it is very important to note that negative coordinates are not supported in Unitechnik 5.2. If the insertion points for the elements are in negative X or Y coordinates, a transformation has to be carried out. Say that your outer negative value in Y is - 100000, in order to export a useful value in Unitechnik 5.2, you will need to select Offset y [mm] = -200000. The operation that is then carried out before exporting is then Y = -100000-(-200000) = 100000. This value is positive and exported.

1581948099505-720.png

Figure 1, Model offset settings

Another important limitation of the supported formats is the limited range of the format, for Unitechnik 5.2, this is [0, 999999] and for 6.0 this is [-999999, 999999].

Tags:
Created by Linus Karlsson on 2019/05/15 15:28
Copyright 2018 StruSoft AB
Impact Documentation