Changes for page Base

Last modified by Adam Carlson on 2020/02/18 07:33

From version < 60.1 >
edited by Adam Carlson
on 2019/05/08 15:50
To version < 61.1 >
edited by Adam Carlson
on 2019/05/08 15:50
< >
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -150,6 +150,19 @@
150 150  
151 151  [[image:drawinsulations1.gif||height="1015" width="1379"]]
152 152  
153 +(% class="wikigeneratedid" %)
154 += Center of Gravity =
155 +
156 +This command displays a dot where the center of gravity (COG) is located. If only one polyline, outer, is selected then the COG is shown for just this polyline. If the outer and inner polyline is selected then the inner one is observed as an opening.
157 +
158 +[[image:COOOG1.png]]
159 +
160 +//Figure 14: Center of Gravity//
161 +
162 +The GIF below will show how to use this command. the first two times, only the outer polyline is selected, the third time, both an outer and inner polyline is selected.
163 +
164 +[[image:COG1COG.gif||height="978" width="1380"]]
165 +
153 153  = Settings =
154 154  
155 155  * [[Default property visibility>>doc:IMPACT Applications.IMPACT for AutoCAD.Base.Property visibility.WebHome]]
Copyright 2018 StruSoft AB
Impact Documentation