Default settings "MTO_HIDE_GROUP_BARS" value 1 hides straight bars, "MTO_HIDE_GROUP_STIRRUPS" value 1 hides stirrups from reinforcement groups in the table of reinforcement.

Last modified by Adam Carlson on 2021/06/30 10:49

Stirrups and bars that are now included in a reinforcement group can be set so they should not be shown in the drawing schedule. The reinforcement group is already included in the reinforcement schedule. 

Now the information about how they should be bent is present in the reports with the following variables.

Two new reinforcement default settings "MTO_HIDE_GROUP_BARS" value 1 hides straight bars from reinforcement groups in the table of reinforcement. "MTO_HIDE_GROUP_STIRRUPS" value 1 hides stirrups from reinforcement groups in the table of reinforcement. Note these settings needs to be combined with "GROUP_MTO_PARTS" to have any effect. 

 

Contents

Tags:
Created by Adam Carlson on 2021/02/08 15:37
Copyright 2024 StruSoft AB
IMPACT Wiki