Production setting added a special clause for the"Move from small holes and Cims"(bar mesh) to avoid placement of bars for a given extents distance around rectangular holes.
Last modified by Adam Carlson on 2021/05/18 15:24
The setting is added for the bar mesh in the production settings. It is created to avoid bars crashing into polystyrene. How large the zone is, is set in the production settings as seen in the picture below.
When the change is made, AutoCAD needs to be refreshed and the reinforcement drawn again.
This picture is created before the setting was set to 60. Here it is set to 0.
As can be seen below, the minimum distance is set to 60 and therefore the values are greater than 60.