Reinforcement variable added called "MESH_NAME". This variable automatically generates the mesh name based on the mesh settings

Last modified by Adam Carlson on 2021/06/30 12:39

Reinforcement variable added called "MESH_NAME". This variable automatically generates the mesh name based on the mesh settings.

By adding this setting, the name of a new mesh component will be automatically set by using the mesh properties once those are filled in and you press "OK" button.

If you add "$DIMV" to the setting, it will be replaced by the vertical dimension.

If you add "$QLTV" to the setting, it will be replaced by the vertical quality.

If you add "$SPACV" to the setting, it will be replaced by the vertical spacing.

If you add "$SPACH" to the setting, it will be replaced by the horizontal spacing.

If you add "$DIMH" to the setting, it will be replaced by the horizontal dimension.

If you add "$QLTH" to the setting, it will be replaced by the horizontal quality.

A running number will also be added to the name for separating equal mesh names.

By adding "$NR" you can control were the running number is added, otherwise, it will be added at the end.

So if the setting is "$SPACH-SPACV-$NR

If the horizontal spacing is 150 mm and the vertical spacing is 200 mm the names will be:

"150-200-1", "150-200-2", "150-200-3", "150-200-4"

Note:

79357.png

 

Contents

Tags:
Copyright 2024 StruSoft AB
IMPACT Wiki