New

New: Run export to Unitechnik automatically for slabs, sandwich, solid walls, and insulated walls. (Case 77544)

Fix

Fix: where manually modifying one barmesh and then modifying the other one the first one gets reset. (Case 123441)

Fix: where column sections automatically adjust to the viewport after change in the element type and shop drawing regenerated. (Case 123962)

Fix: Special case where the total height was incorrect. (Case 124317)

Fix: Special case where the element geometry couldn't be created. (Case 123318)

Fix: Special case where the CIM was incorrect turned in the Column section. (Case 122219)

Fix: Special case where exporting a circular hole to unitechnik version 5.2 wasn't correct. (Case 124931)

Fix: special case where CIM was not shown in small detail section. (Case 124741)

Fix: Special case where an opening in the edge of the wall wasn't modeled correct. (Case 124769)

Fix: Special case where a recess was shown as a cut out in BricsCAD. (Case 125051)

Fix: Rename an extended CIM, for instance an electrical duct, didn't work properly. (Case 123884)

Fix: Problem with element geometry on slab elements resulting in dimension lines far away from the element. (Case 123859)

Fix: Incorrect geometry in BricsCAD. (Case 121296)