Fix

Fix: Producibility control shows error for projection for Double Wall element when the projection is bigger than the minimum value. (Case 138313)
Fix: The mass of the lifts wasn't set when calling "MTO All and Redraw". (Case 138239)
Fix: Text for ducts in MEP-keys for DoubleWalls ends up in opposite panel. (Case 138232)
Fix: Alignment value was changed when switching between the tabs in prestressed slab definition. (Case 138184)
Fix: Mass when using multiple materials shown wrong in material table. (Case 138198)
Fix: Special case where the wall section wasn't draw correct. (Case 138162)
Fix: Unitechnik, export of arc segments for duct must have positive angles. (Case 138091)
Fix: Updating the shop drawing, followed by update plan, made the FormSlab move a bit. (Case 138080)
Fix: Attribute "RC_MASS_KG" was not working as it should for sandwich walls. (Case 137780)
Fix: Special case where a linear cim wasn't shown when plotting. (Case 137848)
Fix: where drawing QR code did not work with Impact Go NG. (Case 137871)
Fix: Unable to pre-select walls on floor plan for command "Edit Opening". (Case 138210)