Draw Recess
Version 11.1 by Linus Karlsson on 2019/05/21 12:46
Find the draw recess command.
Select any wall.
The recess dialogue appears.
Important Parameters:
- Type: Specify if the recess is rectangular, circular or use a polygonal shape
- Side: From which side is the recess calculated. You can also think of this as which normal to use.
- Cut Out: Cuts a hole straight through to the other side.
- Distance from front: How far in shall the recess start. A 0 value means from the surface.
- Countersinking: How deep is the recess
- Height: Enter a manual value or choose one on screen (as shown in below example).
- Dimension type: How shall the recess be dimensioned on a shop drawing.
- Annotation: Text used in shop drawing to describe recess.
- Material: If the recess is to be filled with a material, ex.a different mixture of concrete, insulation etc, specify it here. The recess will then be accounted for as a filling.
If you choose 'specify the height on screen', select a base point and then the second point. Use points on the surface (in this case front) that you specified in the dialogue.