Wiki source code of Draw Recess

Last modified by Linus Karlsson on 2019/05/21 12:48

Show last authors
1 (% class="row" %)
2 (((
3 (% class="col-xs-12 col-sm-8" %)
4 (((
5 Find the draw recess command.
6
7 [[image:1518698782371-888.png||height="119" width="198"]]
8
9 //Figure 1: Draw Recess/Filling command//
10
11 Select any wall.
12
13 [[image:1518698725020-857.png||height="268" width="297"]]
14
15 //Figure 2//
16
17 The recess dialogue appears.
18
19 [[image:1518698729341-496.png||height="469" width="595"]]
20
21 //Figure 3: Draw Recess/Filling dialog //
22
23 Important Parameters:
24
25 * **Type**:** **Specify if the recess is rectangular, circular or use a polygonal shape
26 * **Side**: From which side is the recess calculated. You can also think of this as which normal to use.
27
28 * **Cut Out: ** Cuts a hole straight through to the other side.
29 * **Distance from front**:** **How far in shall the recess start. A 0 value means from the surface.
30 * **Countersinking**:** **How deep is the recess
31 * **Height**: Enter a manual value or choose one on screen (as shown in below example).
32
33 * **Dimension type**:** **How shall the recess be dimensioned on a shop drawing.
34 * **Annotation**: Text used in shop drawing to describe recess.
35
36 * **Material**:** ** If the recess is to be filled with a material, ex.a different mixture of concrete, insulation etc, specify it here. The recess will then be accounted for as a filling.
37
38 [[image:1518698734238-889.png||height="275" width="462"]]
39
40 //Figure 4: Draw recess//
41
42 If you choose 'specify the height on screen', select a base point and then the second point. Use points on the surface (//in this case front//) that you specified in the dialogue.
43
44 [[image:1518698739795-938.png||height="257" width="294"]]
45
46 //Figure 5: Draw recess//
47
48 === A recess can be added on all sides ===
49
50 When you draw recess/fillings in the model (floor plan) you can select element or none. If you select none it leaves you with adding recess in the top/bottom for slabs and columns&beams and near face/far face for walls. If you instead select element it gives you access to all sides of the element when you place your recess/filling. The GIFs below gives you some ideas on how to use this.
51
52 [[image:3DR.gif]]
53
54 //Figure 6: Draw recess by using 3DRotate//
55
56
57 [[image:ucs.gif]]
58
59 //Figure 6: Draw recess by using UCS (User Coordinate System)//
60 )))
61
62 (% class="col-xs-12 col-sm-4" %)
63 (((
64 (% class="box" %)
65 (((
66
67
68 {{toc/}}
69 )))
70
71
72 )))
73 )))
Copyright 2018 StruSoft AB
Impact Documentation