Core Filling
Sometimes, the end of a Hollow Core needs to be strengthened. This can be because e.g. a recess is placed in the end and weakens the element.
Figure 1: Hollow Core with a recess in the end
Cores number 2 and 7 (1 in figure 1 ) needs to be filled since cores 3 and 6 are cut (2 in figure 1) by the recess.
Draw Core Filling
Start with launching the command Draw Core Filling.
Figure 2: Draw Core Filling command
The specified area will define which cores that can be filled. All cores that should be filled must be completely inside the "box"
Figure 3: Filling for only core 4 and 5
Figure 4: Filling for cores 2,3,4,5,6, and 7
Select the Hollow Core which the fillings should be added to.
Figure 5: Draw Core Filling
When the Core Fillings dialog appears, all the cores that were inside the "box" will be shown. Start with deleting the cores that should not have the filling.
Figure 6: Core fillings dialog
- Core number
- Start at - relative to the insertion point of the Hollow Core
- Lenght
- Visible on floor plan
- Visible on shop drawing
- Dimension - should the core filling be dimensioned on the shop drawing
Edit Core Filling
Start with launching the command Edit Core Filling.
Figure 7: Edit Core Filling command
Figure 8: Edit Core Filling