Functionality of bended mesh inside Endcap

A new functionality have been added to Revit where the user will be able to add bended mesh in Endcap definitions under Reinforcement tab.

This functionality consists of a couple of steps that has to be done in order to get the bended mesh inside of your endcaps.

Figure 1 -  Step 1: Apply the endcap on a wall by using the Edit Wall command. 

                 Step 2: Insert bended mesh inside endcap by using the Draw Bended Mesh command under Reinforcement tab.

Figure 2 - Step 3: When bended mesh is inserted inside the endcap then we have to capture the bended mesh configuration. This is done trough the Endcap Definition. Where we have to edit the endcap and click on Pick Reinforcements. 

Below is an demonstration of how to add bended mesh inside endcaps.