From version < 15.1 >
edited by Desi Borisova
on 2019/01/10 14:31
To version < 16.1 >
edited by Desi Borisova
on 2019/01/10 14:40
< >
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -23,9 +23,11 @@
23 23  )))
24 24  )))
25 25  
26 -There are different types of CIM defined in the IMPACT database. IMPACT CIM Type paramater is used to identify different types of available Cast in Materials. The user is allowed to choose a type from the list below. If the category of the CIM can not be defined, the user is advised to choose Manual type.
26 +There are different types of CIM defined in the IMPACT database. IMPACT CIM Type paramater is used to identify different types of available Cast in Materials.
27 27  
28 +The user is allowed to choose a type from the list below. If the category of the CIM can not be defined, the user is advised to choose Manual type.
28 28  
30 +
29 29  [[image:IMPACT CIM type.png]]
30 30  
31 31  //Figure 1 - IMPACT CIM Type parameter//
... ... @@ -38,8 +38,10 @@
38 38  
39 39  == IMPACT CIM Mark ==
40 40  
41 -This is a parameter that marks the CIM with a number in the IMPACT database. The parameter will be saved in the IMPACT database with that parameter name. If the element is saved and later on generated in an IMPACT AutoCAD drawing, a CIM with the same number will be generated on the drawing.
43 +This is a parameter that marks the CIM with a number in the IMPACT database. The same CIM number can be found in IMPACT Standard Admin and IMPACT AutoCAD CIM definitions.
42 42  
45 +IMPACT CIM Mark is the parameter that a user must use to make a connection between Revit CIM family and AutoCAD CIM block. If the element is saved in IMPACT Revit and later on generated in an IMPACT AutoCAD drawing, a CIM with the same number will be generated on the drawing.
46 +
43 43  [[image:IMPACT CIM mark.png]]
44 44  
45 45  //Figure 3 - MPACT CIM Mark//
... ... @@ -53,3 +53,5 @@
53 53  [[image:acad name of cims.png]]
54 54  
55 55  //Figure 5 - IMPACT CIM Mark corresponds to the Cast-in Materials numbers, shown in CIM definitions in IMPACT AutoCAD//
60 +
61 +Read also about possibility for creating Project CIM.
Copyright 2018 StruSoft AB
IMPACT Documentation