Lift side

We added a new tab in the Draw and Edit slab command where it is now possible to configure additional lifts on the side of the element. 

Figure 1 - Lift side tab in Draw slab command 

Figure 2 - Lift side tab in Edit Slab command

As you might noticed, the fields Length and Mass are empty in Lift side tab from Draw slab command because the slab has not been drawn yet and the values are not determined yet. The values of these fields are populated in the Edit slab command. 

          Geometry

Length: The length of the slab 

Width: The width of the slab including the tolerance

Height: The height of the slab 

Mass: The mass of the slab 

          Lift side 1 and Lift side 2

Lift Selection: There are two options here - By definition and User defined

Lift type: The type of the lift which is coming from the Slab definition

Side: The side where the lift should be inserted. There are five options - Left, Right, Front, Back and None

Lift capacity: The capacity of the lifts on how much slab weight are supposed to lift. There are two options - 100% and 50%

Name: The name of the lift (CIM mark) defined in Slab definition

Note: When configuring the side lift by having selected the Definition for Lift selection, it will automatically select the name of the lift as "PROXY". This is because the mass and size of the slab is not determined yet. After drawing the slab, it will automatically insert the side lift according to the lifting settings from the Slab definition. 

Figure 3 - Solid Slab having side lifts inserted in Left and Right side