Import Reinforcement Groups
Import Reinforcement groups - Lets you import Reinforcement Groups into IMPACT, that has previously been Exported. Either by a different branch of your company, a consultant, or partner company.
The guide below shows an example of importing Reinforcement Groups - the same guide shall be used when importing Reinforcement Barmarks.
Guide
Importing Reinforcement groups is done by opening the project in question, navigating to components, right clicking Reinforcement Groups, and press Import.
Navigate to the file containing the Reinforcement Groups.
After Clicking OK, a new dialog box appears.
You now have three options.
"Manual selection" - Lets you select each of the Reinforcement Groups you want to import. These will also overwrite existing if a Reinforcement Group already exists with the same name
"Import All" - Imports all reinforcement groups
Choosing Overwrite existing will import all and overwrite all existing if Reinforcement Groups of the same names exist.This feature does not currently work, and will be fixed in a service release in the near future. To import and overwrite existing, using "Manual Selection" is advised.
"Skip all" - Skips, and does not import any Reinforcement Group Components.
Press "OK", when your selection is done, and you are ready to import.
Using the newly imported Reinforcement Groups
To start using the newly imported Reinforcement groups do one of the following below.
- Start up AutoCAD, and you can use your Reinforcement Groups.
- If AutoCAD is already open, Use the command "Reinforcement Groups", to load the newly imported Reinforcement Groups into the IMPACT AutoCAD interface.