Mesh

Last modified by superadmin on 2021/05/04 17:15

The mesh commands are available under Reinforcement - Mesh, see figure 1.

1549033044528-920.png

Figure 1, Reinforcement - Mesh

Bended mesh

The bended mesh is drawn like a normal stirrup with a distribution line and then you change the mesh type to be a bended mesh (see figure 2 for e.g.). The length of the distribution line will then be the length of the bended mesh. A bent mesh can also be added into endcap reinforcement. The weight is calculated by using the mesh spacing of the bars in both directions so it's rather exact. Below figure 2, there is a video describing how a bent mesh is created.

1549032651529-455.png

Figure 2, a part of a wall, including a bent mesh

Video 1 - the creation of a bent mesh

Copyright 2024 StruSoft AB
IMPACT Wiki