UNITECHNIKCIMGROUPIDASTYPEOFMOUNTPART

Last modified by superadmin on 2021/05/04 17:16

Possibility to set the field for the number of the mounting part on the cast in materials.

This only applies to single CIM:s

Not for girders, endstops, ducts, recess boxes, dynamic CIM:s, etc.

If the setting is on it takes the Id from CIM Groups as below:

1e2d12ed.png

https://strusoft.manuscript.com/default.asp?pg=pgDownload&pgType=pgDBAttachment&ixAttachment=162508&sFileName=image.png

The CIM:s in the category "Id 1" becomes 91 and CIM:s in the category "Id 2" becomes 92 and so on.
This only applies for groups with id 1-9.

Example of the IMPACT default setting:

VariableTypeValue
UNITECHNIKCIMGROUPIDASTYPEOFMOUNTPART00

Wit the setting 0 all of the CIM:s are set to 190

1212312r.png

Example with a user default setting:

VariableTypeValue
UNITECHNIKCIMGROUPIDASTYPEOFMOUNTPART01

The CIM:s in the category "Id 1" becomes 91 and CIM:s in the category "Id 2" becomes 92 and so on.
This only applies for groups with id 1-9.