PLACEGIRDERFROMCENTROIDDOUBLEWALL

Last modified by superadmin on 2021/05/04 17:09

Determines if the girders should start being placed from the left side, default (0), or if the girders should start being placed in the center of gravity and continued to the sides (1).

For alternative (0) the first girder will be placed according to the spacing of the mesh. For a single girder the girder normally needs to follow the mesh in order to get a good anchoring.

For a double girder this is not needed and alternative (1) can be used instead. For this alternative the two first girder will be placed with the spacing from the center of gravity (see the picture below). This will give that all girders are placed with the same distance from centre of gravity which will make easier to place the lift later as they normally is aligned with a girder.

Example of the IMPACT default setting:

VariableTypeValue
PLACEGIRDERFROMCENTROIDDOUBLEWALL00

PLACEGIRDERFROMCENTROIDDOUBLEWALL0a.png

PLACEGIRDERFROMCENTROIDDOUBLEWALL0b.png

Example with a user default setting:

VariableTypeValue
PLACEGIRDERFROMCENTROIDDOUBLEWALL01

PLACEGIRDERFROMCENTROIDDOUBLEWALL1a.png

PLACEGIRDERFROMCENTROIDDOUBLEWALL1b.png

Tags:
Copyright 2024 StruSoft AB
IMPACT Wiki