Rectangular beam

Last modified by Adam Carlson on 2022/02/08 14:11

Introduction

This block has the general information for a rectangular beam in shop drawings.

In this article, you can read about how to set up this block and modify it to fit your companies needs.

The drawing types can both consist of specifications and attributes which will be presented more in-depth further down. 

The standard name of the block is _uf_rb, this is one of the blocks that you can have a custom name for.

Setup in Standard Admin

Information about this block has to be set up partially in Standard Admin, these steps will be presented below:
Standard Admin -> Settings -> Common -> Drawings -> Drawing Types and then select the element type, in this case, rectangular beam, right-click and select Properties.

1rb.png

2rb.png

Id and Name can be changed here or outside this dialog. 

The Layout has three options to select from. The difference is how the tables look, for example, the double wall got a line that divides the two panels which the other elements do not have.

The three options are:

  • Standard
  • Double Wall
  • Form Slab

The next six boxes which can be ticked decide if the tables should be included or not for this drawing type. 

The first field, Block file name, is the name of the block, this name must be the same as the dwg located in template drawings (See chapter "Location")

The next two fields Block X & Block Y are the sizes of the block in x and y-direction.

Block justify decides where the insertion point should be, there are three options to select from. The standard justification is Top Right.

The three options are:

  • Top right
  • Top left
  • Bottom right

Visible decides if the block should be visible or not. This should always be ticked if used. 

Which Head file name should be used is decided here. The head file is always placed in the upper right corner of the drawing.

The last two fields Head X & Head Y are the sizes of the head file in x and y-direction.

3rb.png

qq33.png

Specifications

Specifications require more steps to set up and use. To learn how this is done, click here.

Attributes

All attributes that can be used are described in the chapter attributes in the following article by clicking here.

The Blocks

The design of the blocks can almost be as you desire, it can both consist of specifications and attributes.

Note: The insert point of the attributes needs to be inside the block frame.

This is what the standard Strusoft block looks like in a drawing:

5rb.png

Location

The block is located under ...\Standard\1100\1100\templates_drawings. 1100 must be replaced with your company number. 

If the block is not needed, the dwg can be removed from the folder and it will not be shown.

Download the block file

Download the head file

Tags:
Copyright 2024 StruSoft AB
IMPACT Wiki