MarkTextColumnPlan

Last modified by Adam Carlson on 2022/01/20 14:06

Introduction

This block is used to show the properties of the column on plan drawings. 

The standard name of the block is MarkTextColumnPlan, this name can not be changed.

How the block works

The block shows the properties of the element on plan drawings. Which properties that should be shown can be selected with "Settings Plan".

1.png

The block itself looks like this.

2.png

Attributes

The attributes that can be used with this block will be presented below.

Attributes have to be created similar to the picture below.

1626780343810-185.png

When editing an attribute, "Tag" is the attribute name from the tables below and "Prompt" is the description for the attribute if that is desired.

Necessary Attributes

Some attributes are necessary for the block to work properly. Without these AutoCAD will send out messages like the one below.

3.png

For this block, there are three attributes that always need to be there. These are:

BUILDING, FLOOR & PHASE

Attributes that can be used for this block

These attributes can be used for this block.

AttributeDescription

BUILDING

 

FLOOR

 

ELEMENT_ID

 

MASS

 

TRANSPORT_ID

 

PHASE

 

ELEVATION

 

ERECTION_SEQUENCE

 

SIZE

 

LENGTH

 

WIDTH

 

HEIGHT

The Block

The block is located under ...\Standard\1100\1100\templates_drawings. 1100 must be replaced with your company number. 

If the block is not needed, the dwg can be removed from the folder and it will not be shown.

Download the block

Tags:
Copyright 2024 StruSoft AB
IMPACT Wiki