Introduction

This block is used to show the properties of the doublewall on 3D drawings. 

How the block works

Which properties that should be shown can be selected with "Settings Plan".

The block itself looks like this.

Attributes

The attributes that can be used with this block will be presented below.

Attributes have to be created similar to the picture below.

When editing an attribute, "Tag" is the attribute name from the tables below and "Prompt" is the description for the attribute if that is desired.

Necessary Attributes

Some attributes are necessary for the block to work properly. Without these AutoCAD will send out messages like the one below.

For this block, there are three attributes that always need to be there. These are:

BUILDING, FLOOR & PHASE

Attributes that can be used for this block

These attributes can be used for this block.

The Block

The block is located under ...\Standard\1100\1100\templates_drawings. 1100 must be replaced with your company number. 

If the block is not needed, the dwg can be removed from the folder and it will not be shown.

Download the block