MarkTextSolidSlabPlanMirrorY
Introduction
This block is used to show the properties of the mirrored slab in the y-axis on plan drawings.
How the block works
Which properties that should be shown can be selected with "Settings Plan".
If you draw the element with Production -> Cast type -> Mirror y-axis from the beginning then you will get the correct block. If you on the other hand change the cast type later in the properties you will need to do the following steps to update the block.
The procedure is shown below.
You will need to "ATTSYNC" to sync and get the correct block.
The block itself looks like this.
Attributes
The attributes that can be used with this block will be presented below.
Attributes have to be created similar to the picture below.
When editing an attribute, "Tag" is the attribute name from the tables below and "Prompt" is the description for the attribute if that is desired.
Necessary Attributes
Some attributes are necessary for the block to work properly. Without these AutoCAD will send out messages like the one below.
For this block, there are three attributes that always need to be there. These are:
BUILDING, FLOOR & PHASE
Attributes that can be used for this block
These attributes can be used for this block.
Attribute | Description |
ELEV_Z | |
MARK | |
BUILDING | |
FLOOR | |
ELEMENT_ID | |
MASS | |
TRANSPORT_ID | |
PHASE | |
ELEVATION | |
ERECTION_SEQUENCE | |
SIZE | |
LENGTH | |
WIDTH | |
HEIGHT |
The Block
The block is located under ...\Standard\1100\1100\templates_drawings. 1100 must be replaced with your company number.
If the block is not needed, the dwg can be removed from the folder and it will not be shown.