_companyStd
Introduction
This block shows the company name and the company number on all drawings.
Setup in Standard admin
This block does not contain any attributes.
This block is added to all drawings and is linked to the drawing frame and can be seen like this in the drawings.
This information will first be added to the drawing when it is printed. and will be shown as follows
Strusofts own standard has company no 1100, when standards are created each company will get their own impact company no.
The company name can be changed in Standard admin, right-click on common, under settings, select properties, and the description will appear on the drawings where it says $companyname.
The Block
The block is located under ...\Standard\1100\1100\templates_drawings. 1100 must be replaced with your company number.
If the block is not needed, the dwg can be removed from the folder and it will not be shown.