Introduction

This block is used to show the list of reinforcement table body. 

How the block works

This is how the standard Strusoft block looks like in a drawing.

The block itself looks like this.

It is also possible to change the height so it suits your company's needs. The line between the variables can be changed to the desired length which will make the next field show up at that offset distance. 

The example below shows the lines twice as long (from 4.5 mm to 9 mm). This is done to keep one column instead of two.

Attributes

The attributes that can be used with this block will be presented below.

Attributes have to be created similar to the picture below.

When editing an attribute, "Tag" is the attribute name from the tables below and "Prompt" is the description for the attribute if that is desired.

Attributes that can be used for this block

These attributes can be used for this block.

The Block

The block is located under ...\Standard\1100\1100\templates_drawings. 1100 must be replaced with your company number. 

If the block is not needed, the dwg can be removed from the folder and it will not be shown.

Download the block