ElevationOpeningBottomElev
Last modified by Adam Carlson on 2022/01/20 14:10
Introduction
This block is used to show the elevation at the bottom of an opening in the wall on the elevation drawing.
How the block works
This is how the standard Strusoft block looks like in a drawing.
The block itself looks like this:
Attributes
This is the default attribute that is used for this block.
This is also the only attribute that can be present.
Attribute | Description |
ELEVATION_M_CM_U |
The Block
The block is located under ...\Standard\1100\1100\templates_drawings. 1100 must be replaced with your company number.
If the block is not needed, the dwg can be removed from the folder and it will not be shown.