_uposnrt
Last modified by Adam Carlson on 2022/01/20 14:14
Introduction
This block is used to show the CIM bobble on the dimension - top side.
How the block works
To be able to see it the setting "Switch annotation side for dimensions above/below and left/right" needs to be set to "No"
This is how the standard Strusoft block looks like in a drawing.
The block itself looks like this:
Attributes
This is the default attribute that is used for this block.
This is also the only attribute that can be present.
Attribute | Description |
POS |
The Block
The block is located under ...\Standard\1100\1100\templates_drawings. 1100 must be replaced with your company number.
If the block is not needed, the dwg can be removed from the folder and it will not be shown.