_ust100
Introduction
This block is used to show the drawing panel that can be chosen - portrait mode.
How the block works
This is what the standard Strusoft block looks like in a drawing.
The block itself looks like this.
Attributes
The attributes that can be used with this block will be presented below.
Attributes have to be created similar to the picture below.
When editing an attribute, "Tag" is the attribute name from the tables below and "Prompt" is the description for the attribute if that is desired.
Attributes that can be used for this block
These attributes can be used for this block.
Attribute | Description |
TEXT_1 | |
TEXT_2 | |
TEXT_3 | |
TEXT_4 | |
TEXT_5 | |
TEXT_6 | |
CHECKED_BY | |
ELEMENT_DESCRIPTION | |
NO_PIECES_READY_FOR_PRODUCTION | |
BOUNDING_BOX_AREA_M2 | |
ELEMENT_MARK | |
MASS_T | |
VOLUME_M3 | |
FACTORY | |
PROJECT | |
DRAWING | |
SLAB_THICKNESS | |
APPROVED_BY | |
DESIGNED_BY | |
DRAWING_SCALE | |
DRAWING_STATUS | |
DRAWING_REVISION | |
APPROVED_DATE | |
PRELIMINARY_DATE | |
DRAWING_TYPE | |
STYLE | |
ELEMENT_TYPE | |
PRODUCT | |
MATERIAL_CODE | |
MASS_KG | |
NET_AREA | |
GROSS_AREA | |
VOLUME | |
VOLUME_L | |
IMP_MATERIAL_NAME | |
IMP_MATERIAL_DESCRIPTION | |
IMP_ELEMENT_THICKNESS | |
NO_PIECES | |
ELEMENT_MARK_CHANGED_DATE | |
BUILDING | |
FLOOR | |
ELEMENT_ID | |
TRANSPORT_ID | |
MASS | |
PHASE | |
LENGTH | |
WIDTH | |
HEIGHT | |
VOLUME_INNER_PANEL | |
VOLUME_OUTER_PANEL | |
VOLUME_INNER_PANEL_L | |
VOLUME_OUTER_PANEL_L | |
VOLUME_INNER_PANEL_M3 | |
VOLUME_OUTER_PANEL_M3 | |
MASS_INNER_PANEL | |
MASS_OUTER_PANEL | |
MASS_INNER_PANEL_T | |
MASS_OUTER_PANEL_T | |
MASS_INNER_PANEL_KG | |
MASS_OUTER_PANEL_KG | |
VOLUME_INSULATION_M3 | |
VOLUME_INSULATION_L | |
IMP_MATERIAL_NAME_INNER | |
IMP_MATERIAL_NAME_INSULATION | |
IMP_MATERIAL_NAME_OUTER | |
IMP_MATERIAL_DESCRIPTION_INNER | |
IMP_MATERIAL_DESCRIPTION_INSULATION | |
IMP_ELEMENT_THICKNESS_INSULATION | |
IMP_MATERIAL_DESCRIPTION_OUTER | |
REMARK | New in Q3/2023 |
The Block
The block is located under ...\Standard\1100\1100\templates_drawings. 1100 must be replaced with your company number.
If the block is not needed, the dwg can be removed from the folder and it will not be shown.
If you wish to change the block when the project is already created, the block needs to be edited on the project level instead. ...\Project\1101\Yourproject\components\templates_drawings.