NOTIFICATIONLIFTPOINTHOLEFORMSLAB
Last modified by Peter Karlsson on 2022/02/03 09:27
This variable gives you a warning if you have a lift point inside a hole.
The check is performed with the commands "Create shop drawings" and "Update shop drawing".
If the value is set to 3, a popup notification is shown.
If the value is set to 2, a notification bubble is shown. Note: It is first shown after you have made the shop drawing/ updated the drawing.
Example of the IMPACT default setting:
Variable | Type | Value |
---|---|---|
NOTIFICATIONLIFTPOINTHOLEFORMSLAB | 0 | 0 |
No warning is showing regarding this.
Variable | Type | Value |
---|---|---|
NOTIFICATIONLIFTPOINTHOLEFORMSLAB | 0 | 1 |
The message is shown in the AutoCAD command bar. Note: this is not possible for the moment.
Example with a user default setting:
Variable | Type | Value |
---|---|---|
NOTIFICATIONLIFTPOINTHOLEFORMSLAB | 0 | 2 |
Example with a user default setting:
Variable | Type | Value |
---|---|---|
NOTIFICATIONLIFTPOINTHOLEFORMSLAB | 0 | 3 |