BAR_PROJECTION_TOLERANCE
Last modified by Oskar Kristinsson on 2025/09/08 11:51
This variable allows you to set the tolerance for the bar projection in the bar mesh.
These are the settings for the example below
As it is shown in the picture above the min bar projection is set to 25mm.
The tolerance variable will give you some adjustments to that
Example of the IMPACT default setting:
| Variable | Type | Value |
|---|---|---|
| BAR_PROJECTION_TOLERANCE | 0 | 0 |
The default value is set to 0.9mm, meaning that if a bar gets the value 24.1mm, it will be approved as shown in this picture
As shown in the picture below, if the distance is 1mm from the given value in production settings, the bar will not be approved.
Example of the IMPACT custom setting:
| Variable | Type | Value |
|---|---|---|
| BAR_PROJECTION_TOLERANCE | 0 | 2 |
This variable is set to have tolerance 2mm and there for bar with 23mm projection is approved and not with 22mm as shown a bit lower
