Detailed Hole Specification summary
Introduction
The report finds summarise the holes/openings/recesses in the project.
Report Setup
General report setup. All the fields have to be filled as it prints a sum row at the end of each page.
Page max X and Page max Y defined the maximum size of the report page.
The x-axis is the columns A, B, C, and etc. and the Y-axis is the rows 1, 2, 3, and etc.
Continuous Header is defined in which row the header and footer start, and in this case, it starts from row 0.
Continuous start row(in this case it is row 12) is where the main info starts and ends in the Continuous end row(in this case it is row 41)
In this case, there is no summary there for the value is 0
Header setup:
Here is how the header is set up for this report.
As you can see we have those x and y values for each field, so the program knows where to put the specific information into the report.
As mention above the Continuous header starts at row 0 to row 11 in the Y direction.
Here are the fields that can be added to the Header and footer:
Fields | Description |
BUILDING | |
DIVISION | |
FACTORY | |
PHASE | |
PROJECT | |
PROJECT_SUMMARY | |
PROJECT_TRIMED | |
REPORT_NAME | |
REPORT_PAGE_NUMBER | |
REPORT_PRINT_DATE | |
REPORT_REVISION | |
REPORT_REVISION_DATE | |
REPORT_TITLE | |
SELECTION_PRODUCT | |
USER_DIVISION_CITY | |
USER_DIVISION_COUNTRY | |
USER_DIVISION_DESCRIPTION | |
USER_DIVISION_FAX | |
USER_DIVISION_NAME | |
USER_DIVISION_PHONE | |
USER_DIVISION_STREET | |
USER_DIVISION_ZIPCODE | |
USER_MOBILE | |
USER_NAME | |
USER_PHONE | |
USER_SIGNATURE | |
USER_TITLE |
Selection setup:
the standard setup for the selections.
Continuous setup:
Here in Continuous setup is where you set up all the information about holes in this case.
As you can see, here you define only one row because this row will be the bases for this report, from row 11 to 40 like shown further up.
The fields you can add to this section are listed below.
Fields | Description |
CIM | |
CIM_NUMBER_OF | |
DESCRIPTION | |
FRIEZE | |
NAME | |
NUMBER_OF_HOLES | |
OPENING_AREA | |
OPENING_BOTTOM_ENDCAP | |
OPENING_DIAMETER | |
OPENING_ENDSTOP | |
OPENING_GEOMETRY | |
OPENING_HEIGHT | |
OPENING_LEFT_ENDCAP | |
OPENING_RIGHT_ENDCAP | |
OPENING_THICKNESS | |
OPENING_TOP_ENDCAP | |
OPENING_TYPE | |
OPENING_WIDTH | |
PRODUCTION_CODE | |
RADIUS_TOP_EDGE | |
RECESS_ANNOTATION | New in Q3/2023 |
Print report
From Report Tool
It is possible to make the normal selection on what to print, but there is added the possibility to select which type of openings included in the report. There can be selected between Openings (doors and windows) and “Recesses and holes” it is possible to select both.
From Cast Planning
It is possible to select between 3 print options, depending on the openings that are wanted.