Reinforcement Bending Schedule with pictures pr. Element mark
Introduction
This report summarises the bent reinforcement in the project based on each barmark pr element mark.
Report Setup
General report setup. All the fields have to be filled if you want a summary row at the end of each page.
Page max X and Page max Y defined the maximum size of the report page.
The X-axis is the columns A, B, C, etc. The Y-axis is rows 1, 2, 3, etc.
Continuous Header Row defines in which row the header and footer start, and in this case, it starts from row 0.
Continuous Start Row (in this case from row 9) is where the main information starts and Continuous End Row (in this case until row 62) is where the main information ends.
If the last field would be filled a summary for each page would be created at the end of the page.
Header setup:
Here is how the header is set up for this report.
As you can see we have different X and Y values for each field. This is done so the program knows where to put in the specific information into the report.
As mentioned above, the continuous header starts at row 0 to row 8 in the Y direction.
Here are the fields that can be added to the Header and Footer:
Fields | Description |
BUILDING | |
DIVISION | |
ELEMENT_MARK | |
FACTORY | |
FLOOR | |
FORM | |
PHASE | |
PROJECT | |
PROJECT_SUMMARY | |
PROJECT_TRIMED | |
REPORT_DATE | |
REPORT_NAME | |
REPORT_PAGE_NUMBER | |
REPORT_PRINT_DATE | |
REPORT_REVISION | |
REPORT_REVISION_DATE | |
REPORT_TITLE | |
REPORT_USERNAME | |
SELECTION_PRODUCT | |
START_DATE | |
USER_DIVISION_CITY | |
USER_DIVISION_COUNTRY | |
USER_DIVISION_DESCRIPTION | |
USER_DIVISION_FAX | |
USER_DIVISION_NAME | |
USER_DIVISION_PHONE | |
USER_DIVISION_STREET | |
USER_DIVISION_ZIPCODE | |
USER_MOBILE | |
USER_NAME | |
USER_PHONE | |
USER_SIGNATURE | |
USER_TITLE |
Selection setup:
The standard setup for the selections.
Continuous setup:
The Continuous setup is where you set up all the information, in this case, about the bent reinforcement.
As you can see, here you define only one row because this row will be the basis for this report, from rows 9 to 62 as shown further up.
The fields you can add to this section are listed below.
Fields | Description |
CUTLENGTH | |
CUTLENGTH_ROUNDED | |
DIAMETER | |
END_1 | |
END_2 | |
END_DIRECTION_1 | |
END_DIRECTION_2 | |
JIG_RADIUS | |
MASS | |
MEASURE_A | |
MEASURE_B | |
MEASURE_C | |
MEASURE_D | |
MEASURE_E | |
MEASURE_F | |
MEASURE_G | |
MEASURE_R | |
MEASURE_S | |
MEASURE_T | |
MEASURE_U | |
MEASURE_V | |
MEASURE_W | |
MEASURE_X | |
MEASURE_Y | |
NO_OF_IDS | |
QUALITY | |
RC_NAME | |
REMARK | |
REVISION | |
SHAPE_CODE | |
SHAPE_PICTURE | |
SUM |
Print report
From Report Tool
It is possible to make the normal selection on what to print, based on the information you want to get out of the report.
You also have the option to save your selection.
From Project manager
You have 2 options to print this report from the project manager, one is from the model view (shown below) and the other option is from the Element Id tab.
The procedure is the same in both places.