Cast Planning - Perform the Element control on the whole bed
Last modified by Peter Karlsson on 2024/03/12 14:56
It is possible to edit element controls of multiple elements planned on one or more casts.
Conditions
This function requires the following
- The selected casts must be from the same day. If this is not the case, then the element control window will not be opened.
- The control must be on all the selected elements.
- The control must only contain simple checks.
- The “Status” on the Control and the Parameters must be the same for all elements.
- If the selected cast contains only one element then the “normal” Element control window will be opened and work as usual.
- RM/Settings/Element Control Settings: The last 3 element control settings must be set to No.
- Any change is applied to all involved element.
The function is available in the following places in Cast Planning
- Calendar View
- Detail View
Note
Note that when having multiple elements no inspection attachments are shown. The functions Add/Remove controls are not available either. Remark is editable.
The figure below is for desktop version.
IMPACT Go - Perform the element control on the whole bed.
Cast Planning - Perform the element control on the whole bed (1).
Cast Planning - Perform the element control on the whole bed (2).
Cast Planning - Perform the element control on the whole bed (3).
The following three settings (see red rectangle) must be set to No;