Possibility to use C-bars as edge reinforcement in left and right edge for walls.

Last modified by Adam Carlson on 2021/06/17 14:26

The change what bar/stirrup should be used is done in "Reinforcement Templates".

1620733740560-810.png

The change is made in the "Edge reinforcement" tab.

1620733879636-555.png

This can apply to insulated walls, sandwich walls, and solid walls.

1620733985113-908.png

If it is desired to have the barmarks shown as in the example above then the setting in project properties "Use barmark definitions" needs to be set to "Yes".

1620733713710-733.png

The naming will follow the rules set with the reinforcement variable "BARMARK_STIRRUP"

1620734195939-552.png

The name for the stirrup is as follows:

1620734001541-464.png