Draw Hanger Detail
Last modified by Adam Carlson on 2022/12/20 12:57
Start with launching the command Draw Hanger Detail.
The first thing to do is to select the slab(s) that need support. In this example, the second slab from the left is selected.
The next thing is to select the supporting slabs. The slab on the left and the slab on the right of the slab that needed support are selected.
Specify first corner point, here the edge is selected of the second slab.
Specify other corner point, here a point a bit further up is selected. This creates an area that will be supported with the hanger.
The next step is to select which hanger detail that should be used.
This is what the final result looks like.
Below a GIF is showing the steps presented in the article.