New

New: The Element ID is now retained after renaming the assembly. (Case 123921)

New: Possibility to draw ducts by picking the lines or points. (Case 118822)

New: New feature to add stirrups connected to CIM. (Case 103196)

New: New feature that makes it possible for a user to save a new element with the same ID as a temporary element. (Case 122361)

New: Improved functionality for barmarks. (Case 120885)

New: Feature that will make it possible to decide what type of lift/bracing that is inserted with insert/open lift command. (Case 124480)

New: Annotation to recesses. (Case 124203)

Fix

Fix: Symbolic lines for recesses was not shown. (Case 124141)

Fix: Resolved issue where the question 'Do you want to create a new mark or keep the mark' popped up too many times after a change. (Case 124026)

Fix: Resolved issue where some dimensions with 0 mm were added to the shop drawing. (Case 124259)

Fix: Resolved issue where SMART CIM configurations did not recalculate properly when applied on new element. (Case 123886)

Fix: Resolved issue where side lifters were resetting after applying 'Insert/update lift' two times. (Case 124256)

Fix: Resolved issue where edit element automatically updated position of lifts and bracings even if 'Keep position' were selected. (Case 123882)

Fix: Opening endcap tag was positioned wrong. (Case 124145)

Fix: Fixed the issue where Reinforcement could not be inserted in wall. (Case 123351)

Fix: Cannot apply reinforcement template. (Case 123601)

Fix: Values that are exceeding the length of the element is not possible to enter. (Case 124397)

Fix: The geometry of the wall is following the wall when picking the lines. (Case 124239)

Fix: Resolved the issue where Level 1 endcap could not be added when there was a filed region in the endcap detail. (Case 124031)

Fix: Resolved issue where replace element did not work as expected. (Case 122081)

Fix: Resolved issue where panel thickenings were not included in the center of gravity functionality. (Case 124481)

Fix: Resolved issue where elements from an external model were not saved properly. (Case 123188)

Fix: Resolved issue where components were hosted wrong in the wall and the drawing became messy. (Case 125331)

Fix: Resolved issue where beam ends were not working as expected. (Case 124126)

Fix: Resolved issue where angles in beam ends did not work as expected. (Case 124125)