Introduction

Design Status History report can be printed from Project Manager Design status history window or the Drawings tab. It can also be printed from Model view or Element Id grid.

Report Setup

General report setup. All the fields have to be filled as it prints a sum row at the end of each page.

Page max X and Page max Y defined the maximum size of the report page.
The x-axis is the columns A, B, C, and etc. and the Y-axis is the rows 1, 2, 3, and etc.

Continuous Header is defined in which row the header and footer start, and in this case, it starts from row 0.

Continuous start row(in this case it is row 2) is where the main info starts and ends in the Continuous end row.
There is no summary in this report.

As you can see, almost all values are 0 and that is because this is not a traditional report to print but more of extraction of data from the database.

Header setup: 
Its possible to add header fields to the report but in the example it has not been added.

As mention above the Continuous header starts at row 1.

Here are the fields that can be added to the Header and footer:

Selection setup:
the standard setup for the selections.

Continuous setup:

Here in Continuous setup is where you set up all the information about holes in this case.

As you can see, here you define only one row because this row will be the bases for this report.. 

The fields you can add to this section are listed below.

Print report

From Drawing view

When clicking on "Print" you will be prompt with the option to select between different reports.

Example

Here is an example of the report.

Download

You can download the report template here