Reinforcement Follow up
Introduction
This report summarize all reinforcement types and specifies the members of a Reinforcement Group.
This is a design report that also can be printed from production. When printed from production there will be a set of data for each project. There is one document for each element type.
Report Setup
General report setup. In this case the summary row is in the top of the report
Page max X and Page max Y defined the maximum size of the report page.
The X-axis is the columns A, B, C, etc. The Y-axis is rows 1, 2, 3, etc.
Continuous Header Row defines in which row the header and footer start, and in this case, it starts from row 0.
Continuous Start Row (in this case from row 9) is where the main information starts and Continuous End Row (in this case until row 40) is where the main information ends.
Header setup:
Here is how the header is set up for this report.
As you can see we have different X and Y values for each field. This is done so the program knows where to put in the specific information into the report.
As mentioned above, the continuous header starts at row 0 to row 8 in the Y direction.
Here are the fields that can be added to the Header and Footer:
Fields | Description |
BUILDING | |
DIVISION | |
ELEMENT_TYPE | |
FACTORY | |
FLOOR | |
PHASE | |
PROJECT | |
PROJECT_SUMMARY | |
PROJECT_TRIMED | |
REPORT_NAME | |
REPORT_PAGE_NUMBER | |
REPORT_PRINT_DATE | |
REPORT_REVISION | |
REPORT_REVISION_DATE | |
REPORT_TITLE | |
SELECTION_PRODUCT | |
USER_DIVISION_CITY | |
USER_DIVISION_COUNTRY | |
USER_DIVISION_DESCRIPTION | |
USER_DIVISION_FAX | |
USER_DIVISION_NAME | |
USER_DIVISION_PHONE | |
USER_DIVISION_STREET | |
USER_DIVISION_ZIPCODE | |
USER_MOBILE | |
USER_NAME | |
USER_PHONE | |
USER_SIGNATURE | |
USER_TITLE |
Selection setup:
The standard setup for the selections.
Continuous setup:
The Continuous setup is where you set up all the information. There is also a field for the Header Name as this report is created dynamic.
As you can see, here you define only one row because this row will be the basis for this report, from rows 9 to 62 as shown further up.
The fields you can add to this section are listed below.
Fields | Description |
ALL_MEASURE | One text for all the measures on bended reinforcement |
CUTLENGTH | |
CUTLENGTH_ROUNDED | |
DIAMETER | |
END_HOOK_1_DIRECTION | |
END_HOOK_1_NAME | |
END_HOOK_2_DIRECTION | |
END_HOOK_2_NAME | |
JIG_RADIUS | |
MASS | |
MASS_MESH_PER_M2 | |
MEASURE_TABLE | |
MESK_TYPE | |
NO_IN_GROUP | |
QUALITY | |
RC_AREA | |
RC_NAME | |
RC_TYPE | |
RC_WIDTH | |
REMARK | |
REVISION | |
SHAPE_CODE | |
SHAPE_PICTURE | |
SUM | |
X_ELEMENT_MARK_TABLE |
Print report
From Report Tool
It is possible to make the normal selection on what to print, based on the information you want to get out of the report.
You also have the option to save your selection.
There is a special selection part where you can decide what type of reinforcement you want to include in the report.
From Project manager
You have 2 options to print this report from the project manager, one is from the model view (shown below) and the other option is from the Element Id tab.
The procedure is the same in both places.
You need to select what reinforcement types to include.
From Resource Manager
You need to select what reinforcement types to include.