VALIDEDGECUTFORMSLAB
Outer geometry turns red if the element width is narrower then the one set in the definition. If the variable has one or more approved edges in standard admin, the formslab outer geometry will be presented as green.
"Indication if a non-full width FormSlab is missing a defined edge"
If you like the program to warn you if a non-full width FormSlab is missing a formatted edge when needed. Either the element needs to be rotated or a defined edge needs to be added.
Image 1: Edged in FormSlab
There is a parameter in Standard Admin that needs to be added to have this check on the floor plans. In my example above the edge “FINE” is needed to be on some of the edges of a non-full width FormSlab.
Image 2: Parameter setup in IMPACT Standard Admin
Image 3: A non-full width slab that is missing a defined edge
Image 4: Changing the edge to FINE
Image 5: Slab after setting one of the edges to a defined edge.
The program will also accept if the element is rotated on the shop drawing as an alternative way of having the non-full width to be accepted.
Image 6: Rotating slab on shop drawing as alternative
If you want to have more edges that you considered OK you shall use semicolon ";" to separate multiple edges.
Image 7: Adding multiple valid edges
Example of the IMPACT default setting:
Variable | Type | Value |
---|---|---|
VALIDEDGECUTFORMSLAB | 0 | 0 |
Example with a user default setting:
Variable | Type | Value |
---|---|---|
VALIDEDGECUTFORMSLAB | 0 | FINE |