Below are the variables that affect Columns in IMPACT for AutoCAD 

VariableShort descriptionDefault Value
ANNOTATIONBYMOULDSIDECOLUMN  
DWGCOLUMNSECTIONCIMSets if "Show cast-in materials" should be marked as default in the section1
DWGCOLUMNSECTIONCIMALLSets if "Include all cast-in materials" should be marked as default in the section0
DWGCOLUMNSECTIONRCSets if "Show reinforcement" should be marked as default in the section1
DWGCOLUMNSECTIONRCALLSets if "Include all reinforcement" should be marked as default in the section0
DWGCOLUMNSECTIONCIMTOLERANCEAFTERSets the default cast-in material "tolerance after" for the section 200
DWGCOLUMNSECTIONCIMTOLERANCEBEFORESets the default cast-in material "tolerance before" for the section50
DWGCOLUMNSECTIONRCTOLERANCEAFTERSets the default reinforcement "tolerance after" for the section10
DWGCOLUMNSECTIONRCTOLERANCEBEFORESets the default reinforcement "tolerance before" for the section10
DWGDIMADDDIMNBRSECTIONCOLUMN  
DWGTEXTDIMPLANCOLUMN  
Tags:
Created by Linus Karlsson on 2018/07/19 10:49
Copyright 2020 StruSoft AB
IMPACT Documentation